21
5. Then hang the hood on the wall and tighten the screws as figure 4
shown. CAUTION: MAKE SURE THE RANGE HOOD IS SECURE
BEFORE RELEASING!
6. Install the aluminum duct on to the body of the hood and connect the
duct to the exterior exhaust system. Make sure all joints are secure
and air tight. Use certified Silver Tape or Duct Tape to make all joints
secure and air tight (figure 5).
7. Remove the plastic covering on the duct covers at this time. Must
be very careful for the sharp edges on the duct cover. Please ware
protective gloves while install the duct cover to prevent personal injury
and prevents scratch on the cover during installation
8. Place upper duct cover and lower duct cover over the body of the
hood as shown in figure 6. Upper duct cover is the one contains
holes on both side. Slide up the upper duct cover towards the
duct cover’s fix panel. Use two of 4mm x 8mm tapping screws to
secure the upper duct cover onto the panel. Finally secure the lower
duct cover to the hood body by using two of 4mm x 8mm tapping
screws.
CAUTION:
Pay extra attention to sharp edges on the duct cover and
minimize duct covers movements to avoid scratches on the cover.
9. Complete the installation.
