937-426-2703
www.nexsens.com
2091 Exchange Court
Fairborn, Ohio 45324
Buzzer Event
When power is
applied
Beep Type
During telemetry
connection
Status
One short
beep
Two short
beeps
Three short
beeps
System boot
successful
Connection
successfully
established
No signal/connection
failed
During telemetry
connection
Buzzer Pattern Indicators
Table 1:
X2-CBMC Buzzer Pattern Indicators.
During sensor
detection
Three second
beep duration
WQData LIVE
Setup
Successfully
1
8
For direct communication or power application,
connect a UW6 direct communication, solar, or
charging cable to the MCIL-6 to UW6R connector.
a. The device will beep once when powered.
b. Caution: The O-ring within the UW6R
connector may fall out when removing the
yellow cap.
9
Wait up to 60 seconds for the system to check
cellular coverage.
a. Two consecutive beeps = adequate signal
b. Three consecutive beeps = no signal
• If three beeps are heard, move the X2-CBMC
into an area with strong cellular coverage.
• Check cellular coverage through CONNECT
using the link:
nexsens.com/x2apn
10
After 20 minutes, refresh WQData LIVE and
confirm all sensor parameters are shown and
valid sensor readings appear.
a. The device will beep for a duration of three
seconds when detection is complete.
For additional information, please reference the X2-CBMC Resource Library on the NexSens Knowledge Base.
nexsens.com/x2cbmckb
1
WQData LIVE setup is automatically done after sensor
detection.
Figure 2:
Steps 7 & 8 - Connect sensors to the 8-pin
ports and connect the solar panel plug to the 6-pin
port.
