NexSens Technology X2-CB, Руководство пользователя

Страница: 114 / 115

X2 Storage Requirements
The following practices should be carried out when storing an X2 data logger for an extended period of time:
Disconnect the 6-pin SP-series solar power pack or UW6-PW AC power adapter cable from the center port
at the bottom of the X2.
This removes power from the data logger and all connected sensors.
This prevents the solar pack battery from running without recharge and dying as a result.
Disconnect any telemetry antenna(s) to prevent any accidental damage resulting from field removal,
transport, or storage.
Protect all cable and port connections.
Inspect all X2 sensor ports and cable connections ensuring there are no signs of moisture or damage.
Cover all logger or cable receptacle ports with a UW-plug to keep moisture out.
Keep all system cable O-rings and connectors clean by covering them with the included red (8-pin) or
yellow (6-pin) polymer caps. If these caps are no longer accessible, any means of shielding the
connectors from debris is acceptable.
Use the O-ring grease included in the maintenance kit as needed to re-grease the cable/plug connector
O-rings.
Store the X2, SP solar pack or AC adapter and other logger accessories in a dry, climate-controlled
environment.
Check the battery voltage on any SP-series solar power packs monthly.
Ensure the voltage holds at or above 12V.
Place in the sun as needed (normally every 2-3 months) to keep the SLA battery inside topped off.
114