SPECIFICATIONS
PAGE 7 OF 8
Specifications
DT D
AMP
4x0.7
DT D
AMP
4x1.3
Power specifications
Number of channel
4 x amplifiers channel, 2 by 2 bridgeable
Max. output voltage (no load)
4 x 85 Volts
4 x 135 Volts
Max. output power (4 x 8 Ohms)
4 x 360 W atts
4 x 750 W atts
Max. output power (4 x 4 Ohms)
4 x 700 W atts
4 x 1300 W atts
Max. output power (2 bridge x 8 Ohms)
2 x 1400 W atts
2 x 2600 W atts
Audio characteristics
Frequency Response
+/- 0.5 dB from 20 Hz to 20 kHz
Input Impedance
10 kOhms
Input Sensitivity
+5 dBU
+8 dBU
Nominal Gain
32 dB
Dynamic Range (A-weighted)
> 110 dB
THD+N
Typical 0.01 %
Back panel features
Analog audio input
4 x balanced analog inputs on XLR3
Power output
4 x SP4 outputs
Link switch
To use same XLR input for 2 x adjacent channels
Mains sockets
IEC C14 inlet with secure lock
Front panel features
Switch and knobs
Mains On/Off switch and volume control knob per channel
View Meters
4 x LEDs (Signal / -18 dB / -6 dB / Peak) per channel
Amplifier status
Amp Ready and Temperature indicator per channel pair
Mains Requirements
Mains Voltage
Factory set for 120 volts or 230 volts mains operation
Power consumption (Idle)
65 W atts
Power consumption 1/8 max. / 4 Ohms
580 W atts
900 W atts
Power consumption 1/4 max. / 4 Ohms
1100 W atts
1800 W atts
Physical specifications
Dimensions (W x H x D)
480 (W ) x 44 (H) x 370 (D) mm, 19 inches / 1U
W eight
7.5 kg
Operating temperature range
0° C
– 45 ° C
Certifications
CE conformity
2006/95/CE (Low voltage) 2004/108/CE (EMC) 2002/95/CE (RoHS)
Electrical safety certification
CSA, CB, EN60065
EMC certification
EN55103-1 / EN55103-2 / FCC
Ordering information
Pre-configured for 230 volts mains
DTD
AMP
4x0.7C
DTD
AMP
4x1.3C
Pre-configured for 120 volts mains
DTD
AMP
4x0.7U
DTD
AMP
4x1.3U
