Nexgrill The Classic 720-0083-04R, Инструкции по сборке и эксплуатации

Страница: 17 / 34

TO LIGHT THE GRILL BURNER:
Make sure all knobs are “OFF” then turn on
the gas supply from the LP tank. Always
keep your face and body as far from the
grill as possible when lighting.
Your stainless steel grill has an exclusive
patented built-in ignition. The igniter is built
in to the valve. To ignite each burner simply
push and turn the control knobs to the HI
setting, you will hear the valve click as it
sends a spark to the pilot flame. If the
burner does not light wait 5 minutes for any
excess gas to dissipate and then retry.
GRILL LIGHTING INSTRUCTIONS
knob to “OFF”. If the smell of gas is
detected and the igniter is not functioning,
immediately turn the control knob “OFF”.
Allow 5 minutes for any accumulated gas
to dissipate. If the side burner igniter is not
functioning, see the following section for
match lighting.
hand immediately once the burner is lit.
Rotate the control knob to the desired
setting.
WARNING: Always keep your face and body
as far away from the burner as possible
when lighting.
TO LIGHT THE SIDE BURNER
To light the side burner, remove any
cooking utensils from the burner grate.
Push and turn the control knob
counterclockwise to the “HI” position. If the
burner does not light, turn the control
TO MATCH LIGHT THE SIDE BURNER
Hold a lit extended match or lighter near
the side burner ports, turn the control
knob counterclockwise to “HI”. Move your
TO MATCH LIGHT THE GRILL
If the burner will not light after several attempts
then the burner can be match lit.
Lighting rod-Here is your instruction:
Match light extension rod
Use this device to match light your burners
Simply place a lighted match between the coils
on the end of the extension rod and hold next
to the burner to ignite.
If you’ve just attempted to light the burner
with the igniter, allow 5 minutes for any
accumulated gas to dissipate. Keep your
face and hands as far away from the grill
as possible. Insert a lit match attached to
tight lighting rod or lighter through the
cooking grids to the burner.(see next page)
Press the control knob and rotate left to the
HI setting, continue to press the knob until
the burner ignites. Burner should light
immediately. If the burner does not light in
4 seconds turn the knob off, wait 5 minutes
and try again.
14
Keep a spray bottle of soapy water
near the gas supply valve and check
the connections before each use.
Do not attempt to light the grill if odor
of gas is present. Call for service 1-
800-913-8999.