Fig.12
Fig.13
14
Fig.14
Fig.15
U
A1
A2
N
4. Side Burner Valve Assembly
(a) Remove two screws from side burner control
valve face. Insert the side burner valve into the
Side Burner Shelf Control Panel (N). Align the
screws on the valve with the large side of the
holes on the bezel. Slightly loosen the screws
without removing the screws. Slide the screws
down to the smaller holes and tighten the screws
to secure. As shown in Fig.12.
(b) Insert side burner tube over side burner valve
orifice. See Fig.13A1. Use (2) Truss head screws
(BB) attaching side burner (N) to shelf to make
room to install side burner valve. See Fig.13A2.
(c) Push control knob (U) onto valve control stem.
See Fig.14.
(d) Insert the side burner ignition wire to the ignition
module located on the right side control panel.
See Fig.15.
Note: Only need to insert the side burner ignition
wire, the other five wires have been pre-assembled.
