Nexcom Peak 550, Руководство пользователя

Страница: 73 / 82

Peak 550 User’s Guide
BIOS Setup 4- 51
POST(hex) Description
3E Try to turn on Level 2 cache
Note: Some chipset may need to turn on the L2 cache in this stage. But
usually, the cache is turn on later in POST 61h
3E Try to turn on Level 2 cache
Note: Some chipset may need to turn on the L2 cache in this stage. But
usually, the cache is turn on later in POST 61h
BF 1. Program the rest of the Chipset’s value according to Setup. (Later Setup
Value Program)
2. If auto-configuration is enabled, programmed the chipset with pre-
defined values in the MODBINable Auto-Table
41 Initialize floppy disk drive controller
42 Initialize Hard drive controller
43 If it is a PnP BIOS, initialize serial & parallel ports
44 Reserved
45 Initialize math coprocessor.
46-4D Reserved
4E If there is any error detected (such as video, kb...), show all the error
messages on the screen & wait for user to press <F1> key
4F 1. If password is needed, ask for password
2. Clear the Energy Star Logo (Green BIOS only)
50 Write all CMOS values currently in the BIOS stack area back into the
CMOS
51 Reserved
52 1. Initialize all ISA ROMs
2. Later PCI initializations (PCI BIOS only)
-assign IRQ to PCI devices
-initialize all PCI ROMs
3. PnP Initializations (PnP BIOS only)
-assign IO, Memory, IRQ & DMA to PnP ISA devices
-initialize all PnP ISA ROMs
4. Program shadows RAM according to Setup settings
5. Program parity according to Setup setting
6. Power Management Initialization
-Enable/Disable global PM
-APM interface initialization
53 1. If it is NOT a PnP BIOS, initialize serial & parallel ports
2. Initialize time value in BIOS data area by translate the RTC time value
into a timer tick value
60 Setup Virus Protection (Boot Sector Protection) functionality according to
Setup settin