Copyright © 2017 NEXCOM International Co., Ltd. All Rights Reserved.
4
iNAS 330 Hardware User Manual
Chapter 1: Product Introduction
Knowing Your iNAS 330
Front Panel
LED Indicators
LED
Behavior
Description
PW
Steady Green
System power is on.
Flashing Green
System boot in process.
Steady Yellow
System is heating.
Flashing Yellow System is in idle state (Sleep mode).
SYS
Flashing Green
System is restoring to factory defaults.
Steady Yellow
Volume is degraded.
Flashing Green
Firmware upgrade in process.
Steady Red
Volume is damaged.
Flashing Yellow Volume is recovering.
PoE/Temp
Flashing Green
Single PoE status is OK for 802.3at.
Steady Green
Dual PoE status is OK for 802.3at.
Flashing Yellow
Detecting voltage for single 802.3af.
(Power insufficient to boot system with 3 disks.)
Steady Yellow
Detecting voltage for dual 802.3af.
Flashing Red
System temperature is overheating.
(Please shutdown to protect the system.)
LAN1
LAN2
Steady Orange
100Mbps network link.
Steady Green
1G network link.
Flashing Green
Network activity on the LAN.
MGT.
Steady Orange
100Mbps network link.
Steady Green
1G network link.
Flashing Green
Network activity on the management port.
HDD1
HDD2
HDD3
Steady Green
HDD is ready.
Flashing Green
Read and write activity on the HDD.
Steady Red
HDD failure.
LAN
Management Port
Reset Button
LED Indicators
M12 LAN Ports
Reset Button (Restore to Default Settings)
Press and hold this button for 4 seconds to restore the system to factory
default settings. This button can only be pressed when the PW status LED
lights up steady green, indicating that the system is powered on and ready.
M12 LAN Ports
Two M12 PoE LAN ports used to connect network devices.
LAN Management Port
LAN management port used to access the NAS management interface. The
default IP address is 192.168.100.1 with a subnet mask of 255.255.255.0.
