Copyright © 2020 NexCOBOT Co., Ltd. All Rights Reserved.
41
NEX 913C User Manual
Chapter 3: BIOS Setup
Primary IGFX Boot Display
Select the video device which will be activated during POST. This has no
effect if external graphics is present. Secondary boot display selection will
appear based on your selection. VGA modes will be supported only on
primary display. The options are Auto, DVI, eDP/LVDS, VGA and HDMI.
PowerOn After G3
Configures the power state when power is re-applied after a power failure
(G3 state).
Soft-Off by PWR-BTTN
Configures the behavior of the power button when pressed. The options are
Instant-Off and Delay 4 Sec.
ME Function Ctrl
Enables or disables ME function.
Network Stack
Enables or disables UEFI network stack.
Display Configuration
This section is used to configure the graphics settings.
Power Button Control
This section is used to configure system power management settings.
Advanced
Version 2.20.1271. Copyright (C) 2019 American Megatrends, Inc.
Aptio Setup Utility - Copyright (C) 2019 American Megatrends, Inc.
→←: Select Screen
↑↓: Select Item
Enter: Select
+/-: Change Opt.
F1: General Help
F2: Previous Values
F3: Optimized Defaults
F4: Save & Exit
ESC: Exit
Select the Video Device which
will be activated during POST.
This has no effect if external
graphics present.
Secondary boot display selection
will appear based on your
selection.
VGA modes will be supported
only on primary display
Primary IGFX Boot Display
[Auto]
Advanced
Version 2.20.1271. Copyright (C) 2019 American Megatrends, Inc.
Aptio Setup Utility - Copyright (C) 2019 American Megatrends, Inc.
→←: Select Screen
↑↓: Select Item
Enter: Select
+/-: Change Opt.
F1: General Help
F2: Previous Values
F3: Optimized Defaults
F4: Save & Exit
ESC: Exit
Specify what state to go to
when power is re-applied after
a power failure (G3 state).
PowerOn After G3
Soft-Off by PWR-BTTN
ME Function Ctrl
Network Stack
[Power Off]
[Instant-Off]
[Enabled]
[Disabled]
