Without using Epoxy yet, trial fit the wing joiner
into one of the wing panels.
Next, slide the other wing half onto the dihedral
brace until the wing panels meet. If the fit is overly
tight, it may be necessary to lightly sand the
dihedral brace.
Carefully slide the wing halves together, ensuring that
they are accurately aligned.
Firmly press the two halves together, allowing the excess
epoxy to run out. Using a paper towel, clean off the excess
epoxy.
Draw the center line
on the wing joiner
Coat one half of the dihedral brace with epoxy up
to the center line. Install the epoxy-coated side of
the dihedral brace into the wing joiner cavity up to
the center line.
Hold the wing halves together with paper
clamp and rubber band.
Rubber band
(not include)
Paper clamp
(not include)
Nylon wing bolt
(included)
30 min.
Epoxy
3- MAIN WING: Joining the wing halves
5
CA
6x20mm dowel.
Securely glue together. If coming off during flight,
you lose control of your air plane.
YAK-9
