Nexa Royal Air Force Supermarine Spitfire, Инструкция по эксплуатации

Страница: 8 / 27

2mm
BOTTOM VIEW
BOTTOM VIEW
2x20mm screw
..............4
Plastic control horn
............2
Plastic control horn
............2 set
3-Install the aileron control horn as shown.
Adhesive
tape
The rectangular hole on the bottom
of the flap is pre-cut at factory
.
Cut away only the covering.
Control horn Alignment
2-Mark the position of the “foot” of the horn on the aileron. Then, with
the drill make the two holes.
1-Depending on the position of the linkage, determine the location of aileron
control horn.
The horn holes must be perfectly aligned with the axis of articulation.
Pull out servo extension cord with string.
X
X
X
L/R
Assemble left and right
wings the same way.
6mm dia. dowel
(for one wing half only )
CA
Wing: Servo installation INSTRUCTION MANUAL / SPITFIRE
8
Thin CA
Connector
...2