Newworld NW 50ES BLK 444443915, Инструкции по эксплуатации и монтажу

Страница: 11 / 24

3.2 ELECTRIC CONNECTION AND SECURITY
When it comes to connecting you appliance, please follow the instructions below carefully.
- The earthing cable (the green and yellow wire) must be connected to the terminal. Make
sure the insulated cable is connected to a power source during the connection of the cable.
- If there is not any appropriate earthed electrical outlet that conforms with regulations then
call an authorised service immediately.
- The earthed electrical outlet must be near to the cooker – never use an extension cord.
- Make sure the supply cable doesn't touch the cooker's surface, because the cooker gets
hot during use.
- In case of any damage to the supply cable, you must call and arrange a certified and
qualified electrician to replace the cable for you.
- You may damage the cooker if it's wired incorrectly. Any damage due to incorrect wiring
will not be covered under the warranty.
- This appliance is designed to connect to 220-240V and 380-415V 3N Volts of electricity. If
your electricity supply is different than the value above, then call a qualified and authorised
service immediately.
- The electric cable must not touch hot parts of the appliance or the back of the appliance,
otherwise the cable may get damaged and cause the appliance to short-circuit.
- The producer firm declares that it has no responsibility against any kind of damages
and losses that emanate from the following security norms.
- Have a gap of at least 3mm between all active (phase) conductors in case you need to
disconnect it from the electricity supply at some point. This disconnection method is
included in the fixed wiring according to electrical installation regulations.
- This appliance is designed for fixed connection to the power supply. Connecting this
appliance to the power supply must be performed by a qualified and authorised electrician.
A H05VV, H05V2V2 or H05RR type supply cable can be used.
- For a fixed connection, use 3x2, 5mm2 or a 3x4mm2 sized cable according to the power
level of the appliance and the terminal box label.
- Some appliances can be equipped with special plug (Perilex or Norplug). If it is
necessary, change it with the same specified spare part.
- Use 16A/400V 5 pin for perilex plug and 25A/250V for Norplug.
- These plugs can be used only in some countries.