42
/
63
Modem Web Interface
MDM2200
User Manual MDM2200 R3.2 v1.1
Parameter
Description
High Band L.O.
Local oscillator frequency (in GHz) used when the LNB is operating in
high band, which can typically be found in the LNB datasheet.
Only applicable if ‘Band selection’ is used in 22 kHz or Voltage
settings. If ‘Band selection’ is not used, then only set one local oscillator
frequency (as there is no distinction between high and low band).
High Band RF Start
Minimum frequency used by the LNB when operating in high band.
Only applicable if ‘Band selection’ is used in 22 kHz or Voltage
settings. If ‘Band selection’ is not used, then only set one RF Start
frequency
(as there is no distinction between high and low band).
High Band RF Stop
Maximum frequency used by the LNB when operating in high band.
Only applicable if ‘Band selection’ is used in 22 kHz or Voltage
settings. If ‘Band selection’ is not used, then only set one RF Stop
frequency
(as there is no distinction between high and low band).
Current Min / Max
Minimum/maximum allowed current on the RX interface. This input is
required for correct functioning of the current measurement test (see
section
Hardware Test on page 54
). Not visible if single coax LNB is
used.
Transmit
MUC Multiplication
factor
Multiplication factor used by the MUC to convert from IF to RF-band
(as n*transmitted IF freq = transmitted RF freq, where n = multiplication
factor).
MUC RF Start
Minimum RF frequency the MUC can transmit.
MUC RF Stop
Maximum RF frequency the MUC can transmit.
Current Min / Max
Minimum/maximum allowed current on the TX interface. This input is
required for correct functioning of the current measurement test (see
section
Hardware Test on page 54
).
