Physical Description
User Manual forAZ710 Up Converter
version 1.2
7
SHAPING THE FUTURE OF SATELLITE COMMUNICATIONS
3.2.1.4 10.0 MHz Reference Input
This input is used when you need a reference with enhanced stability or when you
need several Converters to be synchronised to the same clock source. The level
should be 0 dBm nominally. This input is only valid if the device is equipped with an
NTC/3462 10 MHz reference frequency module.
3.2.1.5 Ethernet
Connection
A standard RJ-45 connector provides connection to an Ethernet hub in a LAN
(10/100BaseT). You can use the front panel to set the IP address and to mask
while in normal mode.
You can use the Ethernet interface to send RMCP commands to the AZ710 Up
Converter. Send the commands as data in a TCP/IP stream. Use socket number
5933. Make sure the RMCP protocol is exactly the same as for the serial interface,
with one small exception: the RMCP address of the device (that is present in an
RMCP command) is ignored by the receiving device.
3.2.2 C-band
1. Up converted signal C-band
2. L-band signal ouput
3. External L-band signal (optional)
1
2
3
