Installation
User Manual forAZ710 Up Converter
version 1.2
2
SHAPING THE FUTURE OF SATELLITE COMMUNICATIONS
2 INSTALLATION
2.1 Rack
Mounting
The equipment is designed to operate in a 19-inch rack system conforming to IEC
60297.
When you mount the AZ710 Up Converter in a standard 19-inch equipment rack,
make sure to sustain it with L-profiles. If you mount the device with four front panel
screws only, you will damage the device and risk injuring yourself.
Operating the equipment in transportable installations is only permitted for
vehicles, ships or aircraft with the means for environmental conditioning. Operating
the equipment in transportable installations without these means may invalidate the
safety compliance.
When you mount the equipment in the rack, make sure that you do not
compromise the air flow that is needed to safely operate the equipment.
2.2 AC Power Supply
When switching the transmission equipment on, be careful not to
disturb the network.
This equipment is provided with a protective earthing incorporated in the power
cord. Only insert the mains plug in a socket outlet provided with a protective earth
contact (TN type power supply). Any interruption of the protective conductor, inside
or outside the equipment, is likely to make the equipment dangerous. Intentional
interruption is prohibited.
Install the equipment and connect it to the mains power supply system in
compliance with local or national wiring installation standards. Install the AZ710 Up
Converter so that its mains supply socket outlet is easily accessible or that there is
another suitable means to disconnect from the mains supply.
The power supply is set to operate from 100 to 240Vac to 47-63Hz.
