OPS-A
Arc Lamp Power Supplies
Page 10
F. LAMP
. The LAMP button is for manual control of the lamp. When pressed, the lamp will ignite/power
down.
G. Control knob.
The control knob is for setting the parameters specific to each power supply feature.
H. POWER
. This is the AC mains power switch. In the ON position as shown in Figure 2, AC power will
be switched into the main circuitry of the power supply. There is no output from the power supply
until the manual or external command to supply power to the lamp is received with the interlock
condition satisfied.
3.4.2. Rear Panel Controls/Connections
Figure 2 OPS-A Power Supply Rear Panel Connections.
A. AC IN.
Before powering up the system for the first time, it is suggested to have a qualified electrician
verify the wall socket to be used with the power supply meets the requirements for operation as noted.
The line voltage requirements for the OPS power supplies are as follows:
A dedicated power line or line isolation may be required in certain locations, as the electronics contained
in the instrument are sensitive to static electricity and radiated electromagnetic fields. Operation of the
system near intense pulsed sources (lasers, Xenon flash lamps, etc.) may compromise performance.
Before making any electrical connections, verify the power switch is in the OFF position for the OPS.
Model
Input Rating
OPS-A150
95 to 264 VAC, 47 to 63 Hz
OPS-A500
