Newport New Focus 3502, Руководство пользователя

Страница: 25 / 51

23
3.4.1
Power
Make sure that that power switch is in the OFF position. Connect the male end
of the provided AC power cable to the mains supply. Connect the female end to
the three-pronged input receptacle on the back of the Chopper Controller.
WARNING
To avoid electric shock, connect the instrument to building earth-
ground, 3-prong receptacles by using the supplied power cord only.
Failure to observe this precaution can result in damage to the product,
fire, severe injury, or death.
WARNING
Do not position this product in such a manner that would make it
difficult to disconnect the power cord.
WARNING
Position the equipment so that access to the mains ON/OFF switch is
readily available. In the event of a hazard, press the grey Power switch
on the lower right of the front panel to the OFF position to turn power
OFF to the internal electronics and fully disconnect the power cord of
the Controller from mains power.
3.4.2
Connecting the Chopper Head to the Chopper Controller
Make sure that the power switch is in the
OFF
position. Connect the Chopper
Head to the Controller with the provided standard shielded Ethernet cable by
plugging the smaller modular connector of the cable into the Chopper Head and
the larger connector into the MOTOR input on the rear panel of the Chopper
Controller.
3.4.3
Connecting the Chopper Controller to a Computer via USB
The Model 3502 Optical Chopper Controller can be connected to a computer
with a standard USB-A to USB-B cable for computer control and
communication.
3.5
Operation
When the unit is turned on the unit performs a series of internal verifications, the
word
PASS
is briefly displayed on the 5-digit LED numeric display, and it
shows its driving frequency setpoint. The unit is then ready to operate the
Chopper Head.