33
4.7.3 Device Setting and Configuration
Device setup requires:
• Entering the IP address for iServer device (for example 128.100.101.254).
• Specifying Socket number (1000 or 2000 depending on iServer settings).
• Defining RS485 Unit # interface address (1 to 199). Enter "0" for RS232 interface
or for iServer.
• Entering Reading command. Normally set to SRT to obtain reading from the devices.
If you want to change this setting, refer to HTTPget
Section 4.5
.
• Defining the Alarm setup (High/Low, High value, or Low value).
• Specifying Pause Interval. It determines how many seconds each subsequential alarm
notification will be sent.
• Determining Monitor interval. It establishes the interval or time resolution in seconds
for which readings will be obtained from the device.
Figure 4.17 iServer Mail Notifier Device Setting
4.8 RH-Temp Excel Software
The RH-Temp Excel logging software enables you to use Microsoft Excel for logging,
graphing, and storing data from the iServer. For complete information of how to use the
RH-Temp software, click on the Help menu of the main window.
The terminal server setting is noted in the Help file under Options.
Select Command mode to use the Excel software for logging.
Some users will encounter a problem between Excel and the printer driver (see
http://support.microsoft.com/?id=279408) where Excel crashes upon startup with
the RH-Temp spreadsheet. The simplest way to start logging data requires that
you run the Window’s “Add Printer” utility to add a Generic Text-Only printer as
the default printer. Then open the RH-Temp spreadsheet. If this problem occurs,
you should obtain an updated driver as supplied by the printer manufacturer.