25
Configuring The Meter
4.10 MANUAL RESET (M.RST)
Manual Reset (M.RST) is not active unless your meter has analog output capabilities. The menu
will display whether analog output is present or not. This feature allows you to offset the error that
may occur within your setpoint. In order to determine the amount of error, you must compare
your display value to the setpoint 1 value. The difference between these two values is the
amount of error that you may want to enter into Manual Reset (M.RST).
"
M.RST
" only shows if you select analog output as proportional.
1.
Press the
MENU
button until the meter shows "
M.RST
" .
2.
Press the
©
/DEV
button. The meter shows last previously stored 4-digit number (-1999
through 9999) with flashing 4th digit.
3.
Press the
¶
/MAX
button to change the value of the flashing digit.
If you continue to press the
¶
/MAX
button, the flashing digit's value continues to change.
4.
Press the
©
/DEV
button to scroll to the next digit.
5.
Press the
MENU
button to store your selection. The meter momentarily shows "
STRD
",
followed also momentarily by "
RST
" (Reset).
Always choose the value of "
M.RST
" less than "
P.BND/2
". meter will not accept larger values and
displays with flashing "
ER 4
".
4
Note
☞
