17
3.2.2 Set Points
SETPOINT 1:
Press
a
1)
Press
a
, if necessary until
SP1
prompt appears.
Press
d
2)
Display shows previous value of “Setpoint 1” with 1
st
digit
flashing.
Press
b
&
c
3)
Press
b
and
c
to increase or decrease Setpoint 1
respectively.
Holding
b
&
c
buttons down for approximately 3 seconds will speed up the
rate at which the set point value increments or decrements.
Press
b
&
c
4)
Continue to use
b
and
c
to enter your 4-digit Setpoint 1 value.
Press
d
5)
Display shows
STRD
stored message momentarily and then
advance to
SP2
only, if a change was made, otherwise press
a
to advance to
SP2
Setpoint 2 Menu.
SETPOINT 2:
Press
d
6)
Display shows previous value of “Setpoint 2” with 1
st
digit
flashing.
Press
b
&
c
7)
Press
b
and
c
to increase or decrease Setpoint 2
respectively.
Holding
b
&
c
buttons down for approximately 3 seconds will speed up
the rate at which the setpoint value increments or decrements.
Press
d
8)
Display shows
STRD
stored message momentarily and then
advances to
CNFG
only, if a change was made, otherwise press
a
to advance to
CNFG
Configuration Menu.