ELECTRONIC POWER PRODUCTS
COMMUNICATION • NAVIGATION
P.O. Box 1306, Newport Beach, California 92663 • Phone: 714-751-0488 • Fax: 714-957-1621 • E-Mail: [email protected]
www.newmarpower.com
RED #1
BLUE #2
BLUE #1
GREEN #1
YELLOW #1
WHITE #2
NMEA 0183 Out
BLACK #1
Volts Xfmr
Volts Xfmr
LIGHTS On/Off
Current Xfmr
Current Xfmr
5 Amp Fuse
Power Ground
12 VAC
90-300 VAC
(C) +9.5 to
+33 VDC
Installation
Before starting the installation, please read this entire section first.
Finger tighten the screws that mount the instrument bracket - It is not necessary or recommended to use tools.
Drill a 2-1/8” (55mm) mounting hole where you desire to mount the instrument (Figure 1).
Connect the various wires from Cable 1 and Cable 2 as shown in Figures 2 and Figure 3.
Carefully check all your wiring against figures 2 and 3 and then mount the instrument in the hole. Use only finger tension to tighten the bracket
hold-down nuts
Figure 3
Bulkhead Gasket
Mounting Bracket
2 1/8" (55mm) Hole
Finger Tighten Only - Do Not Use Tools
Figure 1
Cable #1
Cable #2
RED #1 - Battery
BLUE #1 - AC Volts (from VT)
BLUE #2 - LIGHTS On/Off
WHITE #2 - NMEA 0183 out
GREEN #1 - Signal Ground
YELLOW #1 - Amps (fromCT)
BLACK #1 - Power Ground
Figure 2
