Page 4
Raymor Showers / Pivot Door Set
LAYOUT PROCEDURE / 2-Sided Shower
Shower Size
Door Assembly
Return Panel
1200mm x 900mm
1155mm (min) to 1175mm (max)
855mm (min) to 875mm (max)
Slide Shower Type
Wall to Boundary Line
1200mm x 900mm
1165mm x 865mm
A
OTHER APPLICATIONS
• The smallest or largest measurement in this table may not be achievable if walls are
not plumb or the floor level.
MINIMUM TO MAXIMUM GUIDE
ACRYLIC TRAY APPLICATION
• Installation of the tray and liner must be completed as per
separate instructions pacakged with the Tray.
• Mark out the outside boundary line 22mm in from the
outside of the Tray (refer Diagram A). This measurement
will allow for walls out of plumb up to 8mm.
• Greater variances to plumb than 8mm at the wall must
be assessed and adjusted because this impacts on the
boundary line.
• Preferably the door and return panel boundary line
remains equal to the tray edge.
PROFINISH
TM
TILE TRAY WITH HOB APPLICATION
• Installation and completion of the framing, wall lining,
tray, waterproofing and tiling must be complete. This is
covered in the ProFinish
TM
Instructions.
• The desired position for the boundary line is the 5mm
inwards of the centre line of the Hob.
• The Layout Table below will allow for approximately 8mm
of variation from plumb at the wall.
• Greater variances to plumb at the wall than 8mm must be assessed how this impacts
on the boundary line.
• Preferably the door and return panel boundary line remains equal to the tray edge.
Recommended measurement that can be used as a cross check for item 2:
22mm
A
