Newland NLS-EM20-EX, Руководство пользователя

Страница: 139 / 187

Startup settings
Data format editing commands
Using the data format editor is like moving a virtual cursor in the input data string. The following commands can be used not only to move the cursor to different positions, but also to select and replace
Exchange, insert data into final output, etc. For the hexadecimal value involved in the command, refer to the appendix ASCII Code Table.
Initial cursor position: point to the first byte of the original barcode information that has not been processed by data format editing.
Like the above barcode, the initial cursor position is in " 1 "To the left.
send command
F1 Send all characters
Command format= F1xx ( xx : The hexadecimal value of the character to be inserted)
Output all characters to the right of the cursor, and then output characters xx .
F2 Send several characters
Command format= F2nnxx ( nn : 00-99 , The length of characters sent; xx : The hexadecimal value of the character to be inserted)
To the right of the output cursor nn Characters, then output characters xx .
F2 Example: Send several characters
Before sending the above barcode content 10 Characters, then send a carriage return. Command string: F2100D
F2 : "Send a few characters" command
10 ：The length of the characters sent (output from the current cursor position)
0D : The hexadecimal value of the carriage return
Output result: 1234567890<CR>
129
Exit settings