Newland HR1550-30 Wahoo, Руководство пользователя

Страница: 179 / 216

**
【
Enter Setup
】
167
【
Exit Setup
】
Chapter 7 Data Formatter
Introduction
You may use the Data Formatter to modify the scanner
’s output. For example, you can use the Data Formatter to insert
characters at certain points in barcode data or to suppress/ replace/ send certain characters in barcode data as it is
scanned.
Normally, when you scan a barcode, it gets outputted automatically; however, when you create a format, you must use a
“send” command (see the “Send Commands ” section) within the format programming to output data. The maximum size of
formatter commands in a data format is 116 characters (non-alphanumeric characters excluded).
Add a Data Format
Data format is used to edit barcode data only. You can program up to four data formats, i.e. Format_0, Format_1, Format_2
and Format_3. When you create a data format, you must specify the application scope of your data format (such as
barcode type and data length) and include formatter commands. When scanned data does not match your data format
requirements, you will hear the non-match error beep (if the non-match error beep is ON).
There are two methods to program a data format: Programming with barcodes and programming with serial commands.
Programming with Barcodes
The following explains how to program a data format by scanning the specific barcodes. Scanning any irrelevant barcode
or failing to follow the setting procedure will result in programming failure. To find the alphanumeric barcodes needed to
create a data format, see the
“Digit Barcodes” section in Appendix.
Step 1: Scan the Enter Setup barcode.
Step 2: Scan the Add Data Format barcode.
【
Add Data Format
】