Use the Velcro
straps to secure the
Main Net to Center
Frame and
Collection Trays.
Unfold the Main
Net (#5) and
starting with the
center, insert the
Curved Support Tubes
into the pockets sewn
into the Main Net – You
may need to lift the
Collection Trays slightly to
align the pockets to the Support Tubes.
Insert a Curved Net
Support Tube into
each of the
Collection Trays.
Extend the red elastic bands under the
table net and attach to your table net
bracket tightening knob. If your table
mounts the net outside the edge of the
table, attach a Side Net Clip (#8) at 15 cm from the
table net, with the open end closest to the net.
7
8
9
10
On each side of mount for
the center/Long Support
Tube, there are square slots
to store the Short Support
Tubes and once folded into
an upright position the
Collection Trays have Velcro
to allow them to stay folded in position.
If you want to utilize the ball recycling feature of
the Versa-Net, you need to remove the Ball Bucket
Extender before placing your Robo-Pong
1040(+)/1050(+)/1055 into the Versa-Net system.
STORAGE
BALL MANAGEMENT
Newgy Industries, Inc.
Tennessee, USA
800-556-3949 • 615-452-6470
[email protected]
www.newgy.com
A
B
You can also use your new Versa-Net by placing
your robot on top of the table in front of the net
and practicing against the robot. When the robot
stops throwing balls, shut off your robot, go to the
back of the net, and pick up the collection bucket*.
Refill your robot with balls from the bucket and
you’re ready to go again!
*If you're using your Robo-Pong on top of the table, place a bucket
(not included) under the collection net.
If you want to be able
to manage the number
of balls played per
session, keep the Ball
Bucket Extender on
your Robo-Pong
1040(+)/1050(+)/1055
when placing it into the
Versa-Net system.
YOU’RE DONE!
6.13.18
C
