Newco AKPA-3 DB-T HW, Инструкция по установке и эксплуатации

Страница: 10 / 24

10
Issued August 2013
PROGRAMMING
SEQUENCE OF PROGRAMMING STEPS FOR THE DIGI-BREW CONTROLLER
∗
Depress and hold QUALITY button until display lights up (Approx. 10 seconds).
∗
You are now in the Program Mode. Functions to be programmed appear in the order in which they are shown in the following
table.
∗
Use the QUALITY button to cycle through the functions to find the one you wish to change.
∗
Use the TEA1/2 button to lower the displayed value and the TEA 1 button to raise the value. Press QUALITY
button to store the changed value and advance to next function.
∗
If the Brewer detects no activity for approx. 60 seconds it will exit the Program Mode, except as noted below .
CODE FUNCTION TO SET SET VALUE OPTIONS TEA BREWER
1A Brew 1 volume (Left Button) OFF, 30 – 255 ounces 30 ounces
1b Brew 2 volume (Right Button) OFF, 30 – 255 ounces 60 ounces
2 Visa-brew time OFF, 30 seconds – 2 ½ minutes 1:45
3 Water Temperature *1 170
°
F – 205
°
F 203 Degrees F
4 Auto Arm ON or OFF On
5A Pre-infusion 1 mode ON or OFF Off
5b Pre-infusion 2 mode ON or OFF Off
6 Pulse brew mode ON or OFF On
6A Pulse brew 1 time *2 1:15
6b Pulse brew 2 time *3 3:15
7A Audible alert mode ON or OFF On
7b Audible alert no. of beeps ON,OFF, 1 – 9 On(Continuous)
9A Filtering flow rate OFF, 0.25 – 1.00 gal. / min .25 GPM
9b Filter capacity *4 OFF, 0.50 – 2.50 gal. X 100 2000 gallons
10 Number of Brews ON or OFF, Clr N/A
11A Auto Warmer Shutoff ON or OFF Off
11b Time Interval before shutoff 0-4:15 N/A
12A Power mode Normal, Power Save, Power Down Normal
12b Power shutdown time *5 30 minutes – 4 hours N/A
End None *6 N/A N/A
*1 Brewer will remain in this sequence indefinitely until CANCEL button is pressed.
*2 Hidden if pulse brew mode is OFF or brew 1 time is OFF.
*3 Hidden if pulse brew mode is OFF or brew 2 time is OFF.
*4 Hidden if filter flow rate is OFF.
*5 Hidden when power save mode is normal.
*6 Program mode will time out in 15 seconds at end of programming sequence.
ERROR MESSAGES
The following table explains the error messages which may be encountered on the brewer. The error messages may be cleared by going
into the program mode, using the brew buttons to display “Clr” and then pressing the cancel button.
ERRORMESSAGE DESCRIPTION CAUSE
Er1 Fill run error The fill solenoid has either run for more than six minutes on the initial tank fill or 3 minutes
in normal operation.
Er2 Heater run error The tank heater has run for more than 30 consecutive minutes.
Er3 Shorted probe Short in the thermistor circuit.
Er4 Open probe Break in the thermistor circuit.
Ful Filter limit reached The selected filtering capacity of the filter has been reached