EN
www.newair.com
9
ASSEMBLY & INSTALLATION
INITIAL SETUP
Remove exterior and interior packing materials and
let the fridge stand for 24
hours before connecting to power, to allow refrigerant to settle.
Once it is
plugged in, let it run for at least 30 minutes before stocking. Do not change the
temperature or adjust any settings during this time.
INSTALLATION
•
Use two or more people to move and install the appliance. Failure to do so
can result in back or other injury.
•
Place your appliance on a floor that is strong enough to support it when it is
fully loaded.
•
Choose a well-ventilated area with temperatures above 60
℉
and below
90
℉
.
•
This appliance is designed for built-in, recessed or free-standing installation.
•
For built-
in installation, leave a 1/4” (6.35mm) space on ea
ch side and at the
top of the appliance to ensure proper air circulation to cool the compressor
and condenser.
•
For freestanding installation, leave the proper clearance around the
appliance. Below are the recommended clearances:
Side: 3/4” (19mm); Top: 4” (100mm); Back: 2” (50mm)
•
Even for built-in installation, you must keep space on each side and at the
top. If you plan to use the unit for a built-in application, please leave at least
0.25 in of space on all sides.
•
The appliance must be installed with all electrical, water and drain
connections in accordance with state and local codes.
•
Make certain that the pipes are not pinched, kinked or damaged during
installation. Check for leaks after connection.
NOTE:
Designed for indoor, home use only. The appliance should not be located next
to sources of high heat or in direct sunlight. Do not store or install the
appliance outdoors, in a garage, basement or in moist areas. Don’t install in a
location where the temperature will fall below 60
℉
. For best performance and
to ensure proper ventilation, do not install the appliance behind a cabinet door
or block the base grille.
