7
A Name You can Trust
The following steps are shown in Figure 2:
1.
Locate a stud or other suitable
support and install hanger
bracket on wall or ceiling. Select a
location where the control knob
on the back of the heater is easily
reachable.
2.
Insert carriage bolt into square
opening of heater handle.
3.
Slide spacer over the carriage bolt
shaft and insert the hanger
bracket opening and hold them in
position.
4.
Slide lock washer and thread nut
onto carriage bolt. Turn and
tighten with wrench.
Do not install less than 6 feet (1.9 m)
from the floor.
E
LECTRICAL
C
ONNECTION
W
ARNING
: Consult local electrical codes in addition to the following
requirements:
1.
Turn off main power supply at the electrical panel.
2.
Route supply wires from circuit breaker to an approved junction box,
located near compact unit heater. These supply wires must be two
conductor non-metallic sheath cable with ground wire. Each heater should
be on an individual, properly fused circuit.
3.
Route supply wires from junction box to G73. These supply wires must be
two conductor metallic sheath (BX) cable with ground wire. Alternatively,
appropriate conduit can be used.
4.
Remove junction box cover of G73 and remove one knockout hole. Insert
approved bushing into hole and feed wire cable through. Tighten bushing
around cable.
