1. Select one Leg (A) and one Leg (B) and lay them opposite one another
and facing in the same direction. See Figure 1.
2. Select one Short Cross Beam, and one Short Support Beam, and bolt the side
frame assembly together with the supplied 9/16” hex bolts and lock washers.
See Figure 1.
Note
: Legs are shown being assembled upside down, as this will be easiest
for assembly and installing the top.
3. Repeat steps 1 and 2 for assembling the opposite side frame assembly.
4. Secure the two Long Cross Beams to the post of the two legs
with the supplied 9/16” hex bolts and lock washers. See Figure 2
5. Repeat Step 4 for the opposite side to secure the two side frame
assemblies to the Long Cross Beams.
6. Secure the leg brackets to the Long Cross Beams with the supplied 9/16”
hex bolts and lock washers. See Figure 3.
7. Repeat Step 6 for the remaining leg brackets.
8. Place the workbench top upside down on a protected surface and mark
the top with a pencil 2” in from the sides, 1-9/16” in from the front
edge, and 3/16” in from the back edge as seen in Figure 4. This boundary
represents the correct mounting location for the steel workbench frame.
9. Place the frame within the marked boundary and attach the top
with the supplied #8 x 5/8” wood screws in the 12 locations provided.
For bamboo top: Drill 1/16” pilot holes and install screws. See Figure 5.
Assemble The Frame
3/16"
2"
1-9/16"
2"
Fig.1
LEG (A)
LEG (B)
Front Edge
Rear Edge
Fig.2
Fig.5
Fig.4
Fig.3
