NEW KON 10 Series, Руководство по эксплуатации, Страница: 13 / 17

13
9
9
.
.
H
H
o
o
w
w
t
t
o
o
r
r
e
e
m
m
o
o
v
v
e
e
a
a
n
n
d
d
i
i
n
n
s
s
t
t
a
a
l
l
l
l
a
a
d
d
i
i
e
e
b
b
l
l
o
o
c
c
k
k
■
Following is t he procedure to remove and install a die block.
※ Note: Be sure to turn off the power and unplug the power plug from the outlet before attempting repairs.
■
TOOLS NEEDED:
Phillips screwdriver.
Allen wrench (located in the accessory bag).
1. Remove the 2 top cover screws
⑩
at the rear of the main unit.
2. There is a fitting pin
⑫
on the front of the top cover
⑨
. Please pull it up and remove the top cover.
3. Remove the 2 front and 2 back side cover screws
⑬
which are for attaching the side cover
⑪
The side covers can now be spread open ( note: please d o not force the side covers into the “open” position).
4. Remove the die block fixing screw
⑯
with the enclosed Allen wrench
5. Disconnect the harness from the depth gauge assembly.
6. Slowly pull on the die block and remove it.
7. Pull the shaft pin
⑰
out of the die block.
8. Prepare the new die block for replacement.
9. Insert the shaft pin
⑰
into the new die block.
10. Place the die block on the die base and connect the depth gauge switch.
11. Pull up the shaft pin
⑰
, insert it into the arm, push the die block all the way in.
12. Attach the die block with the screw
⑯
and firmly tighten .
13. Close the side covers
⑪
and attach with the front and back screws
⑬
.
14. Insert the fitting pin
⑫
into the hole in the front of the top cover
⑨
and attach the top cover
⑨
.
15. Tighten the top cover screws and attach the top cover firmly.
16. The die block replacement is now completed.