New Holland MH2.6, Руководство по ремонту

Страница: 25 / 41

10 SECTION 02 - SAFETY PRECAUTIONS
Motor
Do not run the engine in closed buildings without
proper ventilation capable to remove harmful ex-
haust fumes.
Do not place head, body, limbs, feet, hands or fin-
gers near rotating fans or belts. Be especially care-
ful near blower fans.
Loosen the radiator cap very slowly to relieve sys-
tem pressure before removing it. Always top-up
coolant level with the engine off or idling if hot.
See the Operation and Maintenance Instruction
Manual.
Keep the exhaust manifold and tube free from com-
bustible matters. Fit the machine with shields and
guards when working in the presence of combusti-
ble matter free in the air.
Do not refuel with the engine running, especially if
hot, as this increases fire hazard in case of fuel spill-
age.
Never attempt to check or adjust fan belt tensions
when the engine is running.
Do not adjust the fuel injection pump when the ma-
chine is operating.
Do not lubricate the machine with the engine run-
ning.
Do not run the engine with the air intakes open and
not protected. If this cannot be avoided for service
reasons, place protection meshes on all intakes be-
fore servicing the engine.
Electric system
Pay attention to connect connecting cables to cor-
rect poles (+ to +) and (- to -) at both ends. Do not
short-circuit the terminals. Thoroughly follow in-
structions given in Operation and Maintenance In-
struction Manual.
Always move the key-start switch in the lock position
before servicing or repairing the machine.
Batteries contain SULFURIC ACID. Protect the
eyes when working near the batteries against possi-
ble sprays of the acid solution. Should acid contact
skin, eyes, or clothes, RINSE IMMEDIATELY IN
WATER FOR AT LEAST 15 MINUTES. Seek for im-
mediate medical assistance.
Battery released gas is highly flammable. Leave the
battery compartment cover open during recharging
to improve ventilation. Never check battery charge
by placing metal objects across the posts. Keep
sparks or open flames away from batteries. Do not
smoke near the battery to prevent explosion hazard.
Before any maintenance or repair, make sure that
there are no fuel or electrolyte leaks from the batter-
ies. If any, correct prior to proceeding with further
work.
Do not recharge batteries in confined spaces. En-
sure proper ventilation is provided to avoid acciden-
tal explosions due to build-up of explosive gas
released during charging.
Disconnect batteries before working on the electri-
cal system or carrying out any other type of work.
Hydraulic system
Pressure fluid escaping from a very small hole can
be almost invisible and still have sufficient force to
penetrate the skin. Always check any suspected
pressure leaks using a piece of cardboard or wood.
Do not use hands. If injured by escaping fluid, obtain
medical attention immediately. If proper medication
is not carried out immediately serious infection or re-
action may develop.
Stop the engine and ensure pressure is relieved
from all systems before removing side panels, hous-
ings, guards and covers. See the Operation and
Maintenance Instruction Manual.
Always use gauges of adequate capacity for pres-
sure testing. Refer to the Operation and Mainte-
nance Instruction Manual or Repair Manual.
Attachments
Always keep head, body, limbs, feet, hands, and fin-
gers away from the bucket and attachments, when
in the raised position.
Prior to any maintenance or repair work, install all
supports necessary to this aim according to local
and national safety regulations.
In case the attachment is to be operated for mainte-
nance or repair purposes, do so exclusively while
sitting in the driver’s seat. Sound the horn before
starting the machine or moving the attachment. Re-
quire that nobody remain near the machine. Raise
the attachment slowly.
Do not use the machine to transport loose objects,
unless proper securing devices are provided.