New Holland MegaCutter 512, Руководство по обслуживанию

Страница: 9 / 21

INTRODUCTION
Protecting the electrical/electronic systems during charging or welding
WARNING
Battery acid causes burns. Batteries contain sulfuric acid.
Avoid contact with skin, eyes or clothing. Antidote (external): Flush with water. Antidote (eyes): flush
with water for 15 minutes and seek medical attention immediately. Antidote (internal): Drink large
quantities of water or milk. Do not induce vomiting. Seek medical attention immediately.
Failure to comply could result in death or serious injury.
W0111A
To avoid damage to the electronic/electrical systems, always observe the following:
1. Never make or break any of the charging circuit connections, including the battery connections, when the engine
is running.
2. Never short any of the charging components to ground.
3. Always disconnect the ground cable from the battery before arc welding on the machine or on any attachments
on the machine.
• Position the welder ground clamp as close to the welding area as possible
• If welding in close proximity to a computer module, then the module should be removed from the machine
• Never allow welding cables to lay on, near or across any electrical wiring or electronic component while welding
is in progress
4. Always disconnect the negative cable from the battery when charging the battery in the machine with a battery
charger.
NOTICE: If welding must be performed on the unit, the battery ground cable must be disconnected from the machine
battery. The electronic monitoring system and charging system will be damaged if this is not done.
Remove the battery ground cable. Reconnect the cable when welding is completed.
Tools
The tools that NEW HOLLAND AGRICULTURE suggests and illustrated in this manual have been:
• Specifically researched and designed for use with NEW HOLLAND AGRICULTURE machines
• Essential for reliable repair operations
• Accurately built and rigorously tested so as to offer efficient and long-lasting operation
By using these tools, repair personnel will benefit from:
• Operating in optimal technical conditions
• Obtaining the best results
• Saving time and effort
• Working in safe conditions
NOTE: The terms "front", "rear", "right-hand" and "left-hand" (when referred to different parts) are determined from
the rear, facing in the direction of travel of the machine during operation.
47390184 16/04/2013
7
Find manuals at https://best-manuals.com