SECTION 00 - GENERAL INFORMATION
00-18
2. With operator sitting in the Operator’s seat with
seat belt buckled, start the engine and
hydraulically extend cylinder rods to align
cylinder with pivot pin, 1. Stop engine.
3. Turn the ignition key to the “ON” position. Move
the boom control into “DETENT” (float) position
with the left foot pedal (press toe down) or left
hand control (push control lever down). Turn the
ignition key to the “OFF” position.
4. If cylinder and boom are not properly aligned, use
a pry bar to align cylinder and boom.
5. Install pivot pin, 1, and secure with retaining
hardware, 2. Torque bolts to 38 N
⋅
m (28 ft. lbs.).
6. Start the engine and hydraulically extend the
second cylinder rod to align cylinder with pivot
pin. Stop engine.
7. If cylinder and boom are not properly aligned, sit
in the operator’s seat with seat buckled, turn the
ignition key to the “ON” position. Move the boom
control to the “DETENT (float) position and turn
the ignition key to the “OFF” position.
8. Use a pry bar and align cylinder with boom and
install pivot pin, 1, and retaining hardware, 2, and
torque to 38 N
⋅
m (28 ft. lbs.).
19995764
1
2
15
MAJOR UNIT OVERHAUL
For a major hydrostatic component or engine repair,
the skid steer cab and boom assembly can be tilted
forward for easier access to the components area.
The figure shows the skid steer properly supported
and the cab tilted forward.
WARNING
Never attempt to tilt the skid steer cab without
using the proper tool and instructions. See more
detail later in this section of the manual and/or
contact your new holland dealer.
16
