New Holland EH35, Руководство по обслуживанию

Страница: 13 / 41

2. ESCAPING PROCEDURE IN CASE OF EMERGENCY
Fig. 2-1 LIFE HAMMER AND "EMERGENCY EXIT"
SEAL
Fig. 2-2 TOW MACHINE PROPERLY
NOTE
Do not pull machine utilizing the brackets welded on
the lower plates of the carbody. These brackets are
provided for pulling lightweight objects. See figure
for better reference.
!
While towing, do not enter between the machine
and towing vehicle.
!
Do not apply a shock load onto the towing rope.
!
Do not use eyes on machine lower frame to tow
machine.
!
Keep the wire rope horizontally, and
perpendicularly to the crawler frame.
!
Tow the machine slowly at low speed mode.
!
For the towing of the machine body, provide
pads to be applied to the corner of crawler frame
to prevent the wire rope and crawler frame from
any damages.
2.2 TOWING THE MACHINE
1. If the machine should become stuck in soft soil
areas it may be necessary to tow the machine.
Attach a wire rope or chain, with the capacity to
pull the machine out, to the lower frame axles.
2. Attach other end to the vehicle used to pull the
machine. Operate the Machine’s Travel Lever
in the proper direction while pulling with the
other vehicle.
2.1 WHEN CAB DOOR DOES NOT OPEN
(CAB spec. only)
(1) Escape from the front window.
(2) Escape from skylight.
(3) When front window and skylight do not open ;
The life hammer is always reserved on the rear
left side of cab. Break the glass on the rear side
of cab, and escape from there.
Break the window glass with care to protect
eyes, and don't fail to break the window on
which label "Emergency exit" is stuck.
(4) In addition, the life hammer is equipped with a
cutter on the lever side to cut the seat belt, etc.
01
-1-4
1