INTRODUCTION
• Disconnect the batteries to place a load on them with a load tester.
• After any work is performed, verify that the battery clamp polarity is correct and that the clamps are tight and safe
from accidental short circuit and oxidation.
• Before disconnecting any pipelines (pneumatic, hydraulic, fuel pipes, etc.), verify that all pressure has been re-
leased. Take all necessary precautions bleeding and draining residual pressure. Always wear the proper safety
equipment.
• Do not alter the lengths of any wires.
• Do not connect any electronic service tool to the engine electrical equipment unless specifically approved by NEW
HOLLAND.
• Do not modify the fuel system or hydraulic system unless approved by NEW HOLLAND. Any unauthorized modifi-
cation will compromise warranty assistance and may affect engine operation and life span.
For engine equipped with an electronic control unit
• Do not weld on any part of the equipment without removing the control unit.
• Remove the in case of work requiring heating over
80 °C
(
176 °F
).
• Do not paint the components and the electronic connections.
• Do not alter any data filed in the electronic control unit driving the engine. Any manipulation or alteration of electronic
components will void engine warranty assistance and may affect the correct working order and life span of the
engine.
Respect of the Environment
• Respect of the environment should be of primary importance. Take all necessary precautions to ensure personnel's
safety and health.
• Inform the personnel of the laws regarding the dispensing of used engine fluids.
• Handle batteries with care, storing them in a well ventilated environment and within anti-acid container.
47793462 14/03/2017
11
