New H3C Technologies H3C S6520X-SI Series, Руководство по установке

Страница: 27 / 99

2-16
Installing and removing a power supply
WARNING!
•
To avoid bodily injury or switch damage, strictly follow the procedures in Figure2-21 and
Figure2-22 to install and remove a power supply.
•
You must provide a circuit breaker for each power supply.
Figure2-21 Installation procedure
Figure2-22 Removal procedure
The S6520X-SI switches (except the S6520X-10XT-SI and S6520X-16XT-SI) each provide two
power supply slots. It comes with power supply slot 1 empty and power supply slot 2 installed with a
filler panel. You can install one or two power supplies for the switch as required. For the power
supplies available for the switch and their specifications, see power supplies in
Hardware
Information and Specifications .
IMPORTANT:
•
An S6520X-18C-SI switch can only use PSR150-A1 or PSR150-D1 power supplies for power
supply when it is installed with an LSPM6FWD firewall module.
•
An S6520X-26C-SI switch can only use PSR150-A1 or PSR150-D1 power supplies for power
supply when it is installed with an LSWM2SP8P, LSWM4SP8PM, LSWM2MGT8P or
LSWM2XMGT8P interface module, or an LSPM6FWD firewall module.
Installing and removing a PSR75-12A, PSR150-A1, or
PSR150-D1
The installation and removal procedures are the same for the PSR75-12A, PSR150-A1, and
PSR150-D1 power supplies. The following procedure installs and removes a PSR75-12A power
supply.
Installing a power supply
1. Wear an ESD wrist strap. Make sure the strap makes good skin contact and is reliably
grounded.
2. Remove the filler panel, if any, from the target power supply slot.
Use a Phillips screwdriver to remove the screws on the filler panel and then remove the filler
panel.
安装电源模块 连接电源线 给电源模块加电 安装电源模块 连接电源线 给电源模块加电 安装电源模块 连接电源线 给电源模块加电
Install the power supply Connect the power cord
Turn on the circuit
breaker
将电源模块断电 拆卸电源线 拆卸电源模块 将电源模块断电 拆卸电源线 拆卸电源模块 将电源模块断电 拆卸电源线 拆卸电源模块
Turn off the circuit
breaker
Remove the power cord
Remove the power
supply