www.newenglandarbors.com
www.newenglandarbors.co.uk
If the light fixture will be hard-wired, continue reading.
If the light fixture will not be hard-wired (i.e. solar powered), disregard
this step.
With the post on its side, run a length of cable along the outer pocket
of the extrusion as shown. Be sure to use the pocket adjacent to the
pre-drilled hole as shown.
Thread the cable through the pre-drilled hole and leave a generous
length to allow electrical hook-up to the light fixture later on.
Tip: To prevent unintentionally pulling the cable out, you may tie
the cable in a
loose
knot.
1
2
STEP T W O
3
Round Lamp Post Instructions
1
2
Pre-drilled Hole
