© New Eagle www.neweagle.net PH: 734.929.4557
4
3.
Setup
The logger is ready to use out of the box and is configured for two CAN bus, baud rate of 250K on CAN1, baud
rate of 500K on CAN2. To start logging follow these simple steps:
1. Connect the logger*
¹
with the harness (sold separately).
2. The other side of the harness is flying leads, the user needs to make a connector based on the pin
definition below.
3. Apply power to the CAN bus and the logger
4. The logger will display data logging screen.
5. After plugging in the USB Drive*
²
, CAN logging is started automatically.
The user can also plug in the USB stick first, then when the logger is powered on, the logging
session will be started automatically.
6. Press the ‘Stop Logging’ button to stop the logging session, and prepare the USB stick for
removal. It is important to stop the logging using this button, otherwise a key cycle will be
required to initiate another logging session.
*
¹
The logger has two connectors, primary connector and secondary connector, primary connector is for data
logging, secondary connector is for extended functionalities, includes analog inputs, digital inputs, serial
transmit, etc. Please refer to the New Eagle VeeCAN320 Data Logger Datasheet for more information.
*
²
The user needs to copy “USB log offload.autorun” file to the USB stick before
logging
.
Please download it from New Eagle Wiki on the ‘NE VeeCAN320 Data
Logger’ page.
http://www.neweagle.net/support/wiki/index.php?title=NE_VeeCAN320_Data_Logger
