NEW BRUNSWICK SCIENTIFIC Innova 2000, Руководство пользователя

Страница: 43 / 55

43
New Brunswick Scientific User’s Guide
8. Secure the temperature module to the main control board with the three ¼-
inch screws and nylon washers provided.
9. Remove the jack cover plate at the rear of the shaker (see Figure 1b) .
Retain the mounting hardware.
10. Mount the RTD jack (round connector) with the hardware used to hold the
cover plate. Mount the chart recorder connectors with the hardware
provided in the jack screw kit (P0100-7641).
11. Carefully route both cables along the lower right side of the shaker and
secure with cable clamps and ½-inch long screws provided.
12. Connect the 4-pin connector coming from the chassis harness assembly to
J101 (must cut tie wrap).
13. Connect the RTD cable’s 6-pin connector to J103 on the temperature
control module.
14. Connect the chart recorder cable’s 10-pin connector to J104 on the
temperature control module.
15. Carefully put the front panel back in place and secure it with screws.
16. Place the unit on its side.
17. Mount the RTD bracket assembly (M1194-5000) with the ½-inch pan head
screws provided.
18. Place the unit in its normal operating position.
19. Reassemble the subplatform and platform
(see Section 6.6) .
20. Reconnect the power cord to the unit.
6.10 Capacity Upgrade Option
This kit (NBS part number M1190-9910), which upgrades the capacity of an Innova
2000 to that of an Innova 2050, consists of counterweighting, hardware and a
subplatform for 12 x 16-inch (30.5 x 40.6 cm) platforms. The platform, however,
much be purchased separately.
Before scheduling the Service Engineer for field installation, it is a good idea to
confirm against the packing list that you have received all the parts.
CAUTION!
Before tightening the screws, make sure that there are no
wires pinched between the front panel and the chassis.