GET A HELPER ! This unit is heavy and may require a second
person for lifting and moving.
Pick a suitable location to work. Open the carton and slit the
corners to open like the illustration at the right. This will give you a
protective work surface upon which to start the assembly of your
new smoker.
Hardware parts list and descriptions are listed on next to last page.
STEP 1.
Build two leg assemblies. Do this by sliding a
long leg and short leg together as shown.
STEP 3.
Place the wood rack hooks into the holes
provided in each end of leg assembly as shown. Now
swing wood rack up so it is perpendicular to the floor.
STEP 2.
Attach 1 leg brace to the outside of each end
of one leg assembly using 10-24 x 1 3/4” screws and
10-24 flange nuts.
STEP 4.
Now with the aid of a helper, take the second leg
assembly, making sure that the two short legs on each
assembly are on the same end, and hook the wood rack
holes on the legs onto the wood rack hooks.
Swing the leg
assembly over
so that it is
parallel to the
opposite leg
assembly.
STEP 5.
Attach the loose end of the leg brace to the
corresponding leg. Turn the leg frame assembly upside
down in preparation for axle and wheel attachment.
STEP 6.
Using a hammer, knock one plastic axle cap
onto one end of the axle. Slide one wheel onto axle.
Slide the axle through the holes in both of the short legs.
Slide on the other wheel and tap on a plastic wheel cap
to secure the axle.
STEP 7.
Turn the leg frame assembly on end
with the wheels on the floor to attach the
smoker chamber. Slide the smoker chamber up
against the frame aligning the four holes in the
legs with the four holes in the bottom of the
body. The smoker chamber should be standing
up on the solid end cap.
For steps 1 through 8, do not tighten bolts until all parts are assembled and attached to smoke chamber.
STEP 8.
Bolt chamber to leg assembly
using 4 1/4-20 x 2” Combo Truss Head
Screws and 4 flange nuts.
TIGHTEN ALL BOLTS AT THIS TIME.
LONG LEG
SHORT LEG
LEG BRACE
