Part
Type
Polarity
matters?
Notes
U2 - U11
10 k
Ω
linear
pot
yes
S1 - S8
SPDT
switch
no Unscrew the top nut, remove both
washers for now (keep the
knurled washer and discard the
anti-rotation one), leave the
bottom nut in place (tighten it
if needed).
LED1 - LED3
orange LED
yes The short leg towards the PCB
top edge (flat side of the
printed circle).
LED4
blue LED
yes The short leg towards the PCB
bottom edge (flat side of the
printed circle).
Now flip all the switches to the down position. Carefully place the
panel on top of the PCB and wiggle it into position. This works best
by slightly tapping the switches one by one with a long object (e.g. a
screwdriver), until they’re all in their mounting holes. Press the
panel into place. Once everything is snug, put washers and nuts
