Neunaber Illumine, Руководство пользователя

Страница: 21 / 57

19
Infinite Hold
Infinite Hold combines the Wet v3 Reverb with a hold (“freeze”) function.
The hold function captures and repeats a 100 ms loop, just enough for a
single note or chord.
The hold is triggered by the Latch/Blend parameter, so you will need
to use an expression controller — either the A/B Footswitch or an
expression pedal.
With LATCH/BLEND at 0%, the hold is reset. Increasing from 0% latches
the signal, looping it indefinitely. This parameter also sets the amount of
the hold signal and reverb as follows:
• 0% Latch/Blend — 0% hold, 100% reverb
• 50% Latch/Blend — 50% hold, 50% reverb
• 100% Latch/Blend — 100% hold, 0% reverb
Set up your expression controller with one end of Latch/Blend at 0% and
the other at the Blend value of your choice.
To use the Infinite Hold effect, start with your expression controller at 0%.
Play the note or chord that you want to hold, then increase the expression
controller to latch. When the hold is active, you may adjust the expression
controller to fine-tune the blend between hold and reverb. To stop the hold
and reset, return the expression controller to 0%.