NEU MASTER NSG0070-US500, Инструкция по эксплуатации

Страница: 15 / 16

ENGLISH ENGLISH
PROTECTING THE ENVIRONMENT
STORAGE
TROUBLESHOOTING
ACCESSORIES
Make sure unit is clean and dry before storing.
Store unit indoors in a dry location. To prevent
damage, wrap the electrical cord so that it is not
crimped during storage.
Recommended accessories for use with your
product are available from your local dealer or
authorized service center.
Warning!
The use of any accessory not
recommended for use with this product could be
hazardous.
Separate collection. This product must
not be disposed of with normal
day that your product needs
replacement, or if it is of no further use to you, do
not dispose of it with household waste. Make this
product available for separate collection.
Separate collection of used products
and packaging allows materials to be
recycled and used again. Re-use of
recycled materials helps prevent environmental
pollution and reduces the demand for raw
materials. Local regulations may provide for
separate collection of electrical products from
the household, at municipal waste sites or by the
retailer when you purchase a new product.
TROUBLE! MATERIAL RUNS OR DRIPS.
WHAT’S WRONG? WHAT TO DO…
Spraying too much material.
knob.
Spraying too slowly. Increase speed of application.
Spraying too close. Increase distance from surface.
Viscosity too thin. Check dilution recommendation.
TROUBLE! MATERIAL DRIPS FROM NOZZLE
WHAT’S WRONG? WHAT TO DO…
Nozzle loose Screw nozzle tight
Nozzle breaks Change
Y-type seal ring of nozzle breaks Change
Material accumulated /clog inside nozzle Clean
TROUBLE! TOO MUCH OVER SPRAY.
WHAT’S WRONG? WHAT TO DO…
Sprayer too far from surface. Reduce distance to surface.
Too much material being sprayed.
TROUBLE! LITTLE OR NO MATERIAL BEING RELEASED.
WHAT’S WRONG? WHAT TO DO…
Spray nozzle/tip clogged. Clean nozzles.
Y-type seal ring of nozzle missing Add seal ring to nozzle and assemble in place
Pickup tube loose or clogged. Check tube.
Canister loose Screw canister tightly in place
Flow control knob setting too low.
Air inlet blocked
Material too thick. Thin material per manufacturer recommendation.