Cleaning
Cleaning the spray gun
Note: Do not immerse the gun in the detergent!
1. Unlock the fan assembly and remove it from the gun
assembly. Align the release latch and pull out the gun.
Press the trigger so that the spray material remaining
the gun flows back into tank.
2. Rotate and remove the tank, empty the residual spraying
material in the tank.
3. For clearing, pour a small
amount of the appropriate
cleaning solution into the
tank (warm soft water for
latex materials; mineral spirits
for oil-based materials)
4. Screw back the tank with the
cleaning solution onto the
spray gun. Attach and lock
fan assembly as per
instruction in page 5.
Attach battery pack back on.
5. Spray cleaning solution for a few
seconds (2-5s) in safety area,
spray for a few seconds again. Then
remove the tank and press the trigger.
6. Wipe and clean the outside of the tank.
7. Turn nut to remove the pattern adjust knob, nut, nozzle
guard, nozzle (sealing ring inside). These are must clean
components after each paint project: nozzle, nozzle sealing
ring, tank sealing ring, suction tube, tank. Other parts need
clear just in case it has paint on them.
8. Washing all these parts with appropriate cleaning solution.
9. Install the removed parts back. Always utilize the
direction/positioning rib.
Note: Never use sharp metal needle or similar to clean the nozzles!
Never use silicone-containing solvent or lubricant to clean the nozzles!
Do not miss the nozzle seal.
10. Check if there is paint on check valve housing. No need
clear it if no paint there. If yes pull the check valve out (Note:
Pull not turn!) for cleaning from tank seat. Turn check valve to
teardown to five pieces. If user happened turned check valve
and left valve head remain in tank seat, please easily return
valve back in and pull it out as whole. Make sure the rubber
valve put back in right direction with its nipple goes into the see
through hole which can seen from top of the check valve.
7
Check
valve
Содержание NSG0060-18
Страница 10: ......
