U
ser
M
anUal
Page 9 of 16
DF-150 User Manual | Rev 1.0
Netzer Precision Motion Sensors LTD Propriety
Preface
Safety
Product Overview
Unpacking
Electrical
Connection
Software
Installation
Mounting
Verification
Calibration
Mechanical ICD
Mounting options
JUNE 2016
All specifications are subject to change without notice
Contents
DF-150 Rotary Electric Encoder
6.
SOFTWARE INSTALLATION
The Electric Encoder Explorer (EEE) software:
■
Verifies Mechanical Mounting Correctness
■
Offsets Calibration
■
Sets up general and signal analysis
This chapter reviews the steps associated with installing the EEE
software application.
6.1 m
inimum
r
equiremenTs
■
Operating system: MS windows 7 , 32 / 64 bit
■
Memory: 4MB minimum
■
Communication ports: USB 2
■
Windows .NET Framework , V4 minimum
6.2 i
nsTalling
The
s
ofTware
Run the Electric Encoder™ Explorer file found on our website:
Encoder Explorer
Sw Tools.
5.3 Electrical connection and grounding
The DF-150 does NOT come with specified cable and connector, however,
do observe grounding consideration:
[1]
The cable shield does not connect to the power supply return line.
[2]
Ground the host shaft to avoid interference from the host system,
which could result in encoder internal noise.
Note
: 4.75 to 5.25 VDC power supply required
