8
NX-507E / NX-508E AUXILIARY MODULES
VII.
INSTALLING THE MODULES
The first thing that must be decided is the address of this particular relay/output module. This is the address that
will be selected when programming the auxiliary devices. To set the addresses use the table below.
"
DipSwitch 4 is used to disable the Tamper feature. ("On" = enabled / "Off" = disabled)
Table VII-1
Address
Dip Switch 1
Dip Switch 2
Dip Switch 3
24 ON ON OFF
25 OFF OFF ON
26 ON OFF ON
27 OFF ON ON
28 ON ON ON
29 OFF OFF OFF
30 ON OFF OFF
31 OFF ON OFF
VIII.
ENROLLING THE MODULES
The NetworX control panels have the ability to automatically find and store in memory the presence of all
keypads, zone expanders, wireless receivers, output modules, and any other device on the keypad buss. This
allows these devices to be supervised by the control panel. To enroll the devices, enter the Program Mode using
the procedure outlined in the control panel Installation Manual. When the Program Mode is exited, the NX
control panel will automatically enroll the devices. The enrolling process takes about 12 seconds, during which
time the “Service” LED will illuminate. User codes will not be accepted during the enrolling process. Once a
module is enrolled, if it is not detected by the control, the “Service” LED will illuminate.
IX.
PROGRAMMING THE MODULES
The Program Mode is accessed by entering [
Á
]-[
8
] (all of the function key LEDs will begin to flash). Enter the "Go
To Program" code (default is [
9
]-[
7
]-[
1
]-[
3
]). If the code was valid, the Service LED will flash, and the function
LEDs will illuminate steady, indicating the device to program should be entered. Next, enter the address of the
NX-508E you wish to program followed by [
#
] (
refer to Table VII-1 on page 8)
. At this point, the Armed LED will
illuminate while it is waiting for a programming location to be entered. Enter the desired programming location.
The Armed LED will begin to flash while a programming location is being entered. Enter [
#
]. If this is a valid
location, the Armed LED will extinguish, the Ready LED will illuminate, and the binary data for the first segment of
this location will be shown on the zone LEDS. To change the data, enter the data followed by [
Á
]. The data will
be entered, and the location will automatically increment to the next segment. The data for that segment will be
displayed. This procedure is repeated until the last segment is reached. Pressing [
#
] will exit from this location.
To review the data, repeat the above procedure and press [
Á
] without entering data first. Each time [
Á
] is
pressed the next segment is displayed. Programming data is always one of two types of data. The first type is
numerical, and can take on values from 0-255 or 0-15 depending on the segment size. The second type is a
feature selection type. Feature selection data is used to turn features on or off.
LCD Keypad Users Note:
All
steps required for programming are the same as the aforementioned LED keypad. The LCD keypad display will
prompt you for the data required. While in the programming mode, and not in a location, the number in
parenthesis is the location you were previously changing. For example, if the display reads "Enter location, then
# (5)", it is reminding you that location 5 was the last location you programmed. In feature selection data, the
numbers of the enabled features will be displayed. The features
not
enabled will display a hyphen (-).
