Network Technologies ENVIROMUX PWR-RMT-RBT, Инструкция по установке и эксплуатации, Страница: 8 / 18

Page 5
Initial Configuration
The iBoot Setup Utility supplied on the distribution CD provides the easiest means to find and
configure your iBoot for use. It can discover all the iBoots on your network, display the current IP
address of each, and allow setting of any valid IP address. The Setup Utility is available on the
distribution CD.
Install and run the iBoot Setup Utility:
1. Load the iBoot CD. (The CD supports
only Windows)
2. Click on Setup.exe
3. Install the iBoot Setup Utility
4. Run the iBoot Setup Utility
Note: The IP address can only be set within the
first two minutes of powering up the iBoot, and
requires a power restart of the iBoot after setting
the IP address. Make sure you have physical
access to the iBoot before attempting to set the
IP Address. The Setup Utility will only work with
iBoots on the same local subnets as the iBoots.
Once the iBoot Setup Utility is run, click on
Discovery to display all the iBoots on your
network. New iBoots will display with the name
Set Location and have either the factory default
IP address of 192.168.1.254 or an IP address
that was automatically assigned by the DHCP
server on your network. If the IP address was
assigned by a DHCP server, no changes to the
IP Address are required.
The IP address field also indicates the IP port
that is used by the iBoot. The standard port for
web browser control is factory default Port 80.
Change the IP Address
1. Click on the row containing the iBoot to
be set. The row will become highlighted.
2. Click on the Set IP Address button.
3. Enter the new IP Address into the form. Click OK when done.
4. A confirmation box is displayed. Click OK to clear the box.
5. Power cycle the iBoot to finish the process. A reminder of which iBoots that require this
power down – power up procedure are indicated by a .
*