Network Electronics SDI-IP-GTW, Руководство пользователя

Страница: 18 / 82

SDI-IP-GTW User Manual
18
Figure 6. Connector usage in the two operating modes
In IP transmit mode, the equipment receives an SDI stream and sends
it to the IP network. In this mode, connect the SDI input signal to
connector 1 marked with SDI IN. For test purposes, the input signal is
looped to output connector 4.
In IP receive mode, the equipment receives an IP stream and sends the
SDI stream out on the two SDI OUT connectors, numbered 2 and 3.
Connector 4 is intended for test purposes. Connector 1 (SDI IN) is
optionally used for an input reference signal. The phase and rate of the
output signal may be locked to this input reference signal.
2.2.6.2 Ethernet data port
Connect the Ethernet data port to the network. In IP transmit mode,
the SDI-IP-GTW will send an IP stream to the network. In IP receive
mode, the SDI-IP-GTW will receive an IP stream from the network.
2.2.6.3 Power supply
Section 2.3 provides details of the power supply, protective earthing
and security. Read all these instructions, prior to connecting the unit to
power mains.
2.2.6.4 Management port
The SDI-IP-GTW provides one Ethernet port for control and
management. Connect the management port to the management
network.
2.2.6.5 Technical Earth
Connect the Technical earth to a suitable earthing point.
2.2.6.6 Alarm
The SDI-IP-GTW provides an alarm relay for connection to external
alarm system.