9
6. Installation
When using it, the back of it can be adsorbed on the iron surface, or the two ends can be fixed to the wall with screws.
1.The Wireless Water Leak Detector/Temperature/Humidity Sensor
(R718WAA) has a built-in magnet (as Figure 1 below).
It can be attached to the surface with iron material during
installation.
To make the installation more secure, please use screws
(purchased separately) to fix the device on the wall or other
objects
Note:
Do not install the device in a metal shielded box or in an
environment surrounded by other electrical equipment to avoid
affecting the wireless transmission of the device.
3. When the sensor probe detects the leak, the device
will send an "alarm" message.
After remove the probe from the accumulated leakage
and drain the remaining water from the sensor, the
device will restore to the "normal" state and send the
"normal" status message.
2. Remove the 3M release paper (as the red part of the
above figure) on the back of the sensor probe and
attach it to the smooth ground that may accumulate
leakage (as the right figure).
The R718WAA can be used in the following scenarios:
Data centers and rooms.
File storage center.
Basement leakage detection
Water pipe leakage detection
The bottom of the cabin detection
This
device is designed to detect water leakage and is not suitable
for detecting hazardous chemical, solvent, oil, fuel, strong acid or
other corrosive liquid.
Note:
Please do not disassemble the device unless it is required to replace the batteries. Do not touch the waterproof gasket, LED
indicator light, function keys when replacing the batteries. Please use suitable screwdriver to tighten the screws (if using an electric
screwdriver, it is recommended to set the torque as 4kgf) to ensure the device is impermeable.
