netvox R313W, Руководство пользователя

Страница: 9 / 10

8
6. Installation
(1) This product does not have a waterproof function. After the screening is completed, please place it indoors.
(2) T
1. Remove the 3M glue on the back of the magnet body
and attach the body to the door frame (please do not stick
it on the rough door to avoid falling off after using the
device for a long time).
Note:

Wipe the door clean before installation to avoid dust
on the door and affect the adhesion of the device.

Do not install the device in a metal shielded box or
other electrical equipment around it to avoid affecting
the wireless transmission of the device.
2. Remove the 3M glue from the bottom of the sensor
probe and attach it to a flat ground position where it may
accumulate water leaks. As shown in the enlarged view
on the right.
The figure shows that the water immersion sensor (R313W) is
used in bathing rooms where there is a possibility of water
leakage in the pipeline.
It can also be applied to the following scenarios:

Data center and computer room

Document storage center

Basement leak monitoring

Water pipe leak detection

Bilge monitoring
The device is designed to detect water leaks and is not suitable
for detecting hazardous chemicals, solvents, oils, fuels, strong
acids or other corrosive liquids.
3.When the sensor probe detects a leak, the flood sensor
device will send an "alarm" message.
Remove the probe from the accumulated leak location;
dry the remaining water inside the sensor. The device is
back to a "normal" state, and send a "normal" status
message.